Hubbardton-forge 346013 Manual de usuario descargar pdf

Installation Instructions G3

For Outdoor Fixtures 346013 & 346013F Page 1 of 3

Hand-Forged, Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

14940 Rev D

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL

INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the

construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum watta

e noted on fixture. Use onl

recommended bulbs with fixture.

Component Parts

Note: Fixture, Post and Cover Cap each sold separately.

A J Bolts

B Fixture post

C Washers (4)

D Split washers (4)

E 5/16 nuts (4)

F Cover Cap (sold separately)

G Fixture

H Set screw

I Rubber Strip

J Fixture Collar

To Install (Figures 1 & 2)

Caution: Be sure power is off at the main breaker box prior to installation.

Site Preparation

1. Run appropriate wiring to the site of the fixture, leaving enough excess wire to

reach the top of the post, plus 12 inches.

2. Pour flat and level concrete base with wiring emerging at the center. Insert J

bolts (A) so approximately 1" of the bolts are exposed above the concrete.

Position J bolts according to the supplied template. Allow concrete to cure

before installing fixture.

Installation

Note: Post may be cut to length as desired before installation begins.

1. Position post over J bolts allowing supply wire to run up though the post and

secure using washers (C), split washers (D) and nuts (E).

2. Place optional cover cap (sold separately) (F) over post to conceal mounting

hardware.

3. Connect fixture wires to supply wires using appropriate wire connectors (not

provided), black to black, white to white and bare copper or green to bare

copper or green. If fixture is wired with twin lead lamp cord, connect smooth

side of fixture wire to black and ridged side to white.

4. Install the rubber strip (I) centered on each inside wall of the fixture collar.

5. Place fixture (G) onto post carefully tucking all wiring down into post and

making sure no wires are pinched between the post and the fixture. Secure with

set screw (H) using a 1/8” hex key wrench (not supplied).

(Figure 1)

(continued)

1 2 3

Indice de contenidos

Pagina 1 - (Figure 1)

Installation Instructions G3 For Outdoor Fixtures 346013 & 346013F Page 1 of 3 Hand-Forged, Vermont-Made Lighting and Accessories P.O. Box 8

Pagina 2 - (Figure 2)

Installation Instructions G3 For Outdoor Fixtures 346013 & 346013F Page 2 of 3 Hand-Forged, Vermont-Made Lighting and Accessories P.O. Box 8

Pagina 3 - (Figure 3)

Installation Instructions G3 For Outdoor Fixtures 346013 & 346013F Page 3 of 3 Hand-Forged, Vermont-Made Lighting and Accessories P.O. Box 8

Comentarios a estos manuales

Sin comentarios

Hubbardton-forge 346013 Manual de usuario

Busca en linea o descarga Manual de usuario para Encendiendo Hubbardton-forge 346013. Hubbardton Forge 346013 User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Encendiendo Hubbardton-forge 346013