Hubbardton-forge 121026 Manual de usuario descargar pdf

Glass Installation Instructions A50

For Hanging Pendants with Banded Glass Page 1 of 2

Please see reverse side for Fixture Installation Instructions.

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

To Install Glass

1. Attach bands (A) to glass (B) by placing band sections around lip of glass and securing with countersunk screws (C)

(Figure 1).

Note: On each band, one hole is threaded and the other is not. Screws must go through the unthreaded hole then

into the threaded hole of the next band.

2. To attach arm to band, grasp the arm so that the larger curled loop is toward the bottom with the tip toward the left.

Start the tip of the loop through one of the rings on the band. Twist the arm 360 degrees, guiding the curl through

the ring, until the curl is completely around the ring as shown in the illustration. Repeat the process for the

remaining arms (Figure 2).

3. To attach the glass to the fixture, position the glass over the fixture body and secure the top curl of each of the arms

to the hooks on the fixture.

Figure 1

Figure 2

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

15652

1 2

Glass Installation Instructions A50 For Hanging Pendants with Banded Glass Page 1 of 2 Please see reverse side for Fixture Installation Instructio

Installation Instructions A7 For Chain Hanging Fixtures Page 2 of 2 CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSO

Modelos relacionados 121025 | 121024 |

Sin comentarios